Using RadBeacon Config for Android
Before you start, make sure to put the beacon in configurable mode. This is normally done by power cycling the beacon. For details see how to put a RadBeacon Dot, RadBeacon USB, & RadBeacon X4 into configurable mode.
1. Scan for Beacons
After opening RadBeacon for Android tap "Scan" in the Action Bar. This will show you the list of beacons. Tap the beacon you want to configure.
2. Edit the settings
Edit any setting you wish to update.
Tap the "Apply" button in the action bar. This will prompt you for the PIN. The default pin is all zeros. Enter the pin and tap the "Apply" button.
4. Saved Settings
If everything worked you should see the "Success" message.